Mesh split plane / mesh trim failing - Grasshopper - McNeel Forum
5 (318) · $ 10.00 · In stock
Hi guys, I’m having some problems splitting a mesh I have of a TPMS gyroid surface. It was created using millipede and then offset a small distance (not sure if that matters). When trying to split the mesh in 2 with an intersecting plane something odd happens. It does not split the mesh into 2 seperate meshes 1 above and 1 below the plane. It splits the mesh as shown in the picture below. Any insight on why this is happening would be greatly appreciated! here is the file with in
Mesh split plane / mesh trim failing - Grasshopper - McNeel Forum
ModeLab Grasshopper Primer Third Edition by Gil Akos & Ronnie
Mesh split - Grasshopper - McNeel Forum
C#ScriptingForGrasshopper 1stedition 20200318, PDF
Pufferfish Food4Rhino
Toward Mass Customized Architecture. Applying Principles of Mass
Computational Segmentation of Timber Slabs with Free Column
RhinoScript101 by David Rutten by Pablo C. Herrera - Issuu
Mesh split plane component fails - Grasshopper - McNeel Forum
Rhino.Inside®.Revit
Mesh Split Problem with disjointed meshes - Grasshopper - McNeel Forum
